The mixing process about concrete batching plant


The mixing process about concrete batching plant
In mixing process, usually it is held in the drum axis angle of about 15 from the horizontal. To discharge the concrete drums below horizontal tilt downward. Tilt drum is the most common type of drum mixer(less than 0.5) in the laboratory and in the field.
The mixers all have the same principle: a cylindrical disc (fixed or rotating) contains concrete, but a group or groups within the blade material and the blade rotating mixing pan scrape the pot wall. Shape of the blade and the axis of rotation are not same.
When using the concrete batching plant, the control panel shows the different blade configuration and translation combinations. Another element is the blade mixer. Sometimes the blades rotating shaft and pan axis (single paddle mixer) are coincide. Other pan mixer has a shaft offset.In these cases, the concrete batching plant has two rotation: blades around its axis of rotation and translation around the shaft. Another possibility is to have the two axes of rotation in a synchronized manner. This is a suspended blade angle near the inner wall of the pot. Its role is to scrape the concrete tends to stagnate in the pot wall near the wall, and to push the rotating blades inside which it encounters.
So when concrete batching plant is working, you should pay attention to the mixing process in some cases that may occur, it is the only way to ensure better production of concrete.  

Pre:The difference between semi-automatic and fully automatic concrete mixer
Next:The purpose presentation twin-shaft concrete mixer